The lid lock flashing reasons causes and repair solutions are for most whirlpool kitchenaid maytag amana and kenmore top loading washing machines.
Maytag washing machine door locked blinking.
Looking at your use and care guide page 31 trouble shooting i have held read more.
Does the drain pump run constantly.
The door remains locked during this time.
The door should unlock after 60 seconds.
This is a guide about unlocking the door on a maytag front load washer.
This can reset the washer and clear the flashing lid lock light.
Is the door locked and the add a garment light on.
It is flashing red door locked.
1 year old it s a 4 3 cu ft.
It s possible the drain hose extends more than 4 5 114 mm into the standpipe.
Is the door locked and the add a garment light off.
Was the washer turned on before being connected to water.
Select drain spin to remove any water remaining in the washer.
Maytag front load washer door will not open.
You could have a failed control console or a bad electronic control board in the washer.
Did you just install.
If the control locked light will not turn off i recommend unplugging the washer for 5 minutes.
Front loaders have a locking mechanism to avoid opening the door during a washing cycle but occasionally this lock will be activated accidentally.
If not i recommend calling a service technician to diagnose and repair the washer.
Answered by a verified appliance technician we use cookies to give you the best possible experience on our website.
During this period you will be able to hear the pump running.
When attempting this make sure power is off to the washer and use extreme caution.
The control lock on bottom right is solid red.
If f8 e1 or lf too long to fill appears in the display the washer is taking too long to fill or the washer is filling and draining.
Is water hooked up to the washer and turned on.
Wait approximately 2 minutes for control to reset.
The door may immediately unlock.
The washer door will unlock at the end of the drain.
While this option is on the fan blows and the load is tumbled periodically for up to 12 hours.
Nothing else will appear to be happening with the machine during this time.
Run a drain and spin cycle.
Reconnect power to washer plug in.
My maytag front load washer has a blinking door locked and the door will not open up.
When using one of these cycles the door will remain locked until the cancel button is pushed.
The door lock led light will blink.
Water remaining in washer after cycle.
If the washer will not unlock at the end of a wash cycle unplug the washer or disconnect power.
After 8 minutes the door will unlock.
I have a control lock on my front load washer.
