Select drain spin to remove any water remaining in the washer.
Maytag washer locked and won t open.
Fresh hold option is on.
I am unable.
Is the door locked and the add a garment light on.
Reconnect power to washer plug in.
When using one of these cycles the door will remain locked until the cancel button is pushed.
Is the door locked and the add a garment light off.
If the door or lid won t open at the end of the cycle then the lock mechanism may be at fault.
The door lock secures the washer door shut during operation.
Was the washer turned on before being connected to water.
Washer won t start lid stays locked.
A lock icon appears on the front of the washer s control panel to indicate the lid is locked and also displays the current progress of the cleaning cycle depending on the model of your maytag washer.
01 door lock motor and switch assembly.
Water remaining in washer after cycle.
Even cutting the power supply did not help read more.
Once the washer door is closed the washer can begin operating.
The door remains locked during this time.
Does the drain pump run constantly.
A washer series by maytag with a low rate of customer satisfaction and a high rate of failure.
Maytag front load washer door will not open.
It is possible that we overloaded the machine but cannot open the door to adjust the load.
When i try to cancel it in order to restart the lid is still locked.
Maytag washer door or lid won t lock.
The lights are lit like it should be okay but it won t start.
I loaded the washer and pressed start.
The washer door will unlock at the end of the drain.
Is water hooked up to the washer and turned on.
If the door lock is defective the washer door will not latch properly.
This is a guide about unlocking the door on a maytag front load washer.
The release is normally accessible from below the door lock or on some models from inside the soap dispenser housing.
Most washers will have a manual release to unlock the mechanism and allow you to open the door or lid.
Maytag washer door or lid won t lock.
Door is locked closed but washer won t start.
Pausing the wash cycle is how it can be disabled.
Wait approximately 2 minutes for control to reset.
While this option is on the fan blows and the load is tumbled periodically for up to 12 hours.
If the washer will not unlock at the end of a wash cycle unplug the washer or disconnect power.